Maybe the DPF has been removed and the regen has been mapped out like Getsome says 2014 Mondeo MK4.5 Business Estate 2.0TDCi 150PS (DW10c) with Android 'Tesla' style headunit Save Share The garage fitted the new vapouriser (I imagine by taking off the exhaust) which was 2 hours labour, and then did a static regen (0.75 hrs labour). I was concerned the car would refuse to do a static regen with soo much soot, but it was fine. On picking up the car the DPF pressure at idle was 0.0kpa and at 2,000 rpm it was 1kpa. 28% loaded. This combined with short journeys and occasional low fuel levels would be enough to cause the problems, but the differential pressure sensor was also flatlined. The DPF stats showed: – 875km average distance between regeneration – 683km since last successful regeneration – 128km since last attempt (unsuccessful) Professional Diagnostic Tools for Ford. iCarsoft offers single- and multibrand Professional Diagnostic Tools for Ford. Use the FD V1.0 scanner to read and clear DTC's (diagnostic trouble codes) and Oil Light/Service Reset. The US V2.0 scanner can also be used for service functions such as: (De)activate Electronic Parking Brake (EPB) mk4's aren't using the passive version. It's the process of regeneration that can either be passive or active. Passive being, you're driving long distance on motorway, thus the exhaust is hot enough to clean the DPF without engine's ECU intervening (active regeneration) by injecting extra fuel to increase exhaust gas temperature. Ford Mondeo Mk4 (2007 - 2013) Diesel Engines (Mk4 Mondeo) DPF regeneration. 2158 Views 35 Replies 12 Participants Last post by Speedlimit, Jun 10, 2015. S. As a result Lucas recommend that exhaust sensors are replaced at the same time as the exhaust system or components such as the DPF or CAT. Exhaust Gas Temperature sensors have many features to help them withstand vibration but it can still take its toll over time. Installation advice. 1. Ensure the exhaust system is cool before starting work. 2. Ford Mondeo car, ECU Remapping, TCU Tuning, Chip Tuning Files, DPF Solution, ECU Programming and Coding, EGR Solution and Diesel Engine Tuning Expert, contact us today on 08456 529530 Fine failed a regen and the loadings reached 300% where it stopped trying to regen. I got the car upto temperature and reset the 3 DPF values back to zero and took it for a steady drive. Once the values reached 80% it started the regen and completed it successfully. Never done it since. If the soot loadings are high do not do a static regen. 4zeJ8.

ford mondeo mk4 dpf regeneration